Carel uChiller UCHBP00000200 - Page 104

104
ENG
µchiller +0300053EN rel. 2.2 - 14.12.2021
Release notes
9.1 Connector/cable table
Ref. Description Wiring terminals
Wire cross-
section (mm
2
)
Lmax (m)
J1 Controller power supply Panel model: plug-in terminal, screw, 2-pin, pitch 5.08 0.5…1.5 10
DIN rail model: plug-in terminal, screw, 2-pin, pitch 5.08 0.21…3.31 10
J2 Inputs S1, S2, S3, S5, ID1, ID2;
outputs Y2, Y2
10-pin Microfi t crimp connector 0.05…0.52 10
J3 Inputs S4, S6, ID3, ID4. ID5 8-pin Microfi t crimp connector 0.05…0.52 10
J4 BMS Plug-in screw terminal, 3-pin, pitch 3.81 0.081…1.31 500
J5 Fbus Plug-in screw terminal, 3-pin, pitch 3.81 0.081…1.31 10
J6 Outputs NO1, NO2, NO3, NO4 6-pin Microfi t crimp connector 0.5...1.31 10
J7 Output NO5 3-pin Microfi t crimp connector 0.5...1.31 10
J8 Unit terminal Connection cable P/N: ACS00CB000010 (L=3m)-/20 (L=1.5m) 0.13 2 (*)
J9 Inputs S7, ID6 4-pin Microfi t crimp connector 0.05…0.52 10
J10 Ultracap 3-pin JST connector 0.13 2
J11 Output NO6 3-pin Microfi t crimp connector 0.5...1.31 10
J14 Unipolar ExV valve CAREL ExV unipolar valve connector, pre-wired - 2, 6 with
shielded cable
Tab. 9.b
(*) device to be incorporated.
10. RELEASE NOTES
The information and functions described in this manual refer to µChiller versions 3.1.4 or higher.