PadScan HD 2
Caresono Technology Co., Ltd 25
7.2.1 Probe cleaning
（1）Check the probe for signs of damage, such as leaking. If any sign of damage appears, stop
using the probe and contact CARESONO for service immediately.
（2）Use a soft cloth dampened with isopropyl alcohol (or an appropriate hospital cleaning agent)
to wipe the probe until it is thoroughly cleaned.
7.2.2 Probe maintenance
（1）Must not hit and drop the probe.
（2）It is recommended to only use ultrasound gel which FDA listed or cleared. If the ultrasound
gel doesn't qualify, it will damage the probe and stimulate the skin.
（3）Clean the probe each time after using it.
7.3 Battery usage and maintenance
（1）For optimum performance, it is recommended to charge and completely discharge a new
battery two to three times before first use.
（2）The battery can be charged and discharged for hundreds of times. When the work time
shortens apparently, please replace it with a new one.
（3）Do not use, store and charge the battery near the fire.
（4）Do not make the battery short circuit, protect the battery from damp; do not disassemble the
battery; do not drop and hit the battery.
（5）The battery should be charged and discharged every two or three months to prevent the battery
from invalidation. Note: The full battery which has not been used for a long time will discharge slowly.
So you should charge the battery which has not been used for a long time before reusing it.
（6）If the battery is deformed, discolored; getting hot; giving off an unusual odor; appearing any
other abnormal phenomena, stop using the battery at once. Remove it from the device or the battery
charger and discard the battery according to the waste handling regulations.
To Next Page
Loading...