LB.05099.02 Pag. 37 18/10/16
4) Milk temperature setting
The milk frother is equipped with a MILK TEMPERATURE REGULATOR which reduces the quantity of sucked milk.
Turn the ring nut clockwise to increase temperature, or turn it anticlockwise to decrease temperature (see diagram).
5) Preset Machine configuration
With this function, all the set up values, machine counters dose setting and password take the default values set up by factory.
- To perform the Preset Machine configuration refer to page 36.
- In case there is not way to preset the machine via the standard procedure, follow the following instructions:
Before starting the procedure, disconnect the boiler temperature probe. To do that disconnect either the connector CN18 on
master pcb (open the electronic box under the drip tray), or the temperature probe placed on top of the boiler (remove the cover
of the machine). To preset the machine switch it OFF by pressing I.G. main switch, then keep pressed the key and switch
the machine ON by pressing the main switch (I.G.) until "Preset Machine configuration" will be displayed on the screen.
PLEASE NOTE: by using the following devices it is possible to upgrade the software.
ST-LINK/V2 for display PCB board
To Next Page
Loading...
