1) Washing the group and filter holder.
It is advisable to carry out these types of washing at the end of each working day.
1a) washing the filter holders.
Carry out the following operations:
Remove the filters from the filter holders and wash both parts under running water.
Remove the remaining coffee using the provided brush ( code N° 95.01773 ) supplied with the machine, to eliminate the coffee
residues from the filters and showers
If the filters get clogged up and you cannot manage to clean them by washing, it is advisable to place it under a naked flame to burn any
coffee particles remaining in the holes.
This operation should not be carried out frequently, as it may damage the filter.
1b) washing the group gasket.
Carry out the following operations:
Insert the blind filter membrane supplied in the filter holder.
Turn the machine ON;
Press the key N. 5 (continue) of the group you want to clean.
Slightly open and close the filter holder a few times, letting the water flow out. Be careful not to let hands and other parts of
the body come into contact with water, in order to avoid danger of burns;
If necessary repeat this operation several times, and remove the remaining coffee from the group gasket by using a cloth.
1c) washing the third duct of the group.
Carry out the following operations:
Insert the blind filter membrane supplied in the filter holder;
Turn the machine ON;
Press the key N. 5 (continue) of the group you want to clean at intervals of 5 seconds around.
1d) Steam wand washing.
To avoid the filling of the holes of the terminal of the steam wand, clean with care after every use.
To Next Page
Loading...
