Model 201CRD & 301CRD Advanced oil burners — Instruction manual
Carlin part number MN2301 Rev. 04/12/04
– 28 –
For other than routine maintenance, contact
a qualified service company. Perform the
following as needed.
• Keep the area around the burner clear
and free from combustible vapors and
liquids.
• Do not obstruct the flow of combustion
and ventilating air.
• Most motors currently used on residential
type burners use permanently-lubricated
bearings, and do not require field lubri-
cation. Read the label on the motor to
determine oiling needs, if any. Do not
over-lubricate. This can cause as much
trouble as not lubricating at all.
Never attempt to use gasoline as
a fuel for this burner, as it is more
combustible and could result in a
serious explosion. Never attempt to
burn refuse or use any fuel other
than # 1 or # 2 heating oil (ASTM
D396).
201CRD & 301CRD burner
User care and maintenance
Refer only to the information on this
page, intended for your use. The
remainder of this manual is intended
only for your service technician.
Failure to comply could result in
severe personal injury, death or
substantial property damage.
Should overheating occur:
(1) Shut off the oil supply to the burner.
(2) DO NOT shut off the control switch to
the circulator or blower.
(3) Contact your oil dealer or service
technician and the fire department (if
needed).
The burner must be cleaned, tested
and adjusted annually by a qualified oil
burner service technician.
To Previous Page
Loading...
