EN
Inspect Cam and Cam followers for excessive wear, replace if excessive wear can
be seen.
Every 5 Years
Replace main shaft bearings. Linear Guide Bearings, Guide Rails and Cams if
excessive wear can be seen.
Use only 502375 (KP2N-20 DIN 51825) Grease for Cam Follower Bearing.
Grease Main Shaft Bearing with 502375 grease.
Check oil level within gearbox
Annually
Replace Gearbox Oil in accordance with manufacturers recommendations or
annually.
Daily Check for any fluid leakage
Weekly
Inspect Linear Bearings, Rod, Cam and Cam followers for excessive wear, replace
if excessive wear can be felt or seen.
6 Monthly
Inspect Piston and Replace Piston Seals / Bellows / Springs.
Inspect Piston & Outlet Ball Checks, replace as necessary.
Inspect Linear Guide Bearing and Guide Rails for excessive wear.
Maintenance
Maintenance schedule
Inspection Operation
Grease Cam Follower Bearings (8 off) with 502375 grease while the pump is
running. Inject about 8 full strokes from a standard grease gun fitted with a
standard collet connector.
Check for any excessive mechanical noise
Check for excessive fluid pressure pulsation
Check oil level within gearbox
3 Monthly
77-3330 R1.3 27/36 www.carlisleft.com
To Next Page
Loading...
