EN
• Suction
- Ø50 I.D. [-1 to 10 bar working pressure]
• Outlet
- Ø38 - 50 I.D. [20 bar working pressure]
Ensure adequate air space around the Pump for maintenance and electric motor cooling requirements.
• Check that the oil plug on top of Gearbox has been replaced with the correct venting plug.
• The vent plug is supplied in a bag attached to the gearbox.
• Ensure the gearbox is filled with oil. (The gearbox is filled with the correct amount of oil at the factory)
INSTALLATION
• Attach suitable flexible hoses to the inlet and outlet connections. E.g.
77-3330 R1.3 8/36 www.carlisleft.com
To Next Page
Loading...
