Caroma INVISI II Series - Removing Internal Components; Pre-installation Component Removal; Button Panel Component Removal; Blanking Panel Component Removal

Removing Internal Components through Access Window
1
1- pre installation 1- with button panel 1- with blanking panel
2 3 4
5 6 7
Dust Cover
“click”
“click”
Inlet
Valve
Assembly
“squeeze”
Bridge
Assembly
Outlet
Valve
Flexible Hose
Ball Valve Inlet Valve
Face Plate
Panel Assembly
Face Plate
Panel Assembly
Blanking Panel
Full Flush
Disconnect Flexible Hose from the Inlet
Valve and the Ball Valve.
Lift tab and slide the Inlet Valve Bracket to
the left.
Remove the Bridge Assembly by squeezing
tabs front and back to disengage from
locking tabs inside the tank.
Lift the Outlet Valve to disengage from
guide ribs in the base of the tank and lay
over on it’s side.
Rotate and remove the Inlet Valve Lift the Outlet Valve from the base of the
tank, roll forwards and rotate so the button
end comes out rst.
NOTE: Reverse procedure to reassemble.