The highest and lowest
temperatures for the day
will be displayed along
with the current outside
temperature.
This reading is from the
sensor connected to RS2.
83
Outside
68
L O
H I
92
Requires an outside sensor (optional accessory) to be installed. To
read the temperature from the outside sensor, press the PROGRAM
and HOLIDAY buttons. The display will then show the current outside
temperature along with the highest and lowest temperatures for the day.
Page 5.2
Viewing the Outside TemperatureViewing the Outside Temperature
Press the PROGRAM
button. While holding
PROGRAM, press the
HOLIDAY button to leave
the Outside temperature
screen.
High temperature
for the day.
Low temperature
for the day.
Current outside
temperature.
PROGRAM
HOLIDAY
OUTSIDE
PROGRAM
HOLIDAY
OUTSIDE
5
Note: If no sensors are connected 2 dashes [- -] will appear on the display.
Carrier
One wired remote sensor may be installed to read
the outside temperature (RS2). The wired sensor
can be connected to the thermostat with up to
150’ of 18 ga., 300’ of 20 ga., Or 450’ of 22ga.
Unshielded, thermostat wire. The wired sensor
can be connected to the thermostat using a two
or three wire installation. If a two wire installation
is required, then RS+5 must be connected to
RSGND (see diagram).
This wire MUST be completely separated
from the thermostat or any other control
wiring and must NOT be in the same
conduit as high voltage wiring.
Press the PROGRAM
button. While holding
PROGRAM, press the
HOLIDAY button to view
the Outside temperature.
To Next Page
Loading...
