ENTER EMERGENCY HEAT: Only available if you have a Heat Pump
installed. To initiate the Emergency Heat feature, press the FAN
button. While holding the FAN button press UP button. The
Cool setpoint display will read ‘EH’ (emergency heat).
the
Press for
Emergency Heat
FAN
HEAT
I2:00
73
Pm
74
Page 12.4
OPERATION: During Emergency Heat operation the
thermostat will turn on the fan and the 2nd stage of heat
when there is a demand for heat. Also during Emergency
Heat the 1st stage of heating or cooling will be unavailable.
EXIT EMERGENCY HEAT: Follow the same steps as entering
Emergency Heat by pressing the FAN and UP buttons. During
Emergency Heat, only OFF and HEAT modes are available by
pressing the MODE button.
Using Emergency HeatUsing Emergency Heat
12
Carrier
To Next Page
Loading...
