EasyManuals Logo

Carrier 40DMC Installation Manual

Carrier 40DMC
28 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #4 background imageLoading...
Page #4 background image
GB-2
Safety precautions
Read this instruction manual thorough-
ly before using the appliance.
Keep all installation, operating and
maintenance instructions carefully and
hand them on if you transfer the appli-
ance to another owner.
This appliance conforms to the Low
Voltage Directive (73/23 EEC) and
Electromagnetic Compatibility Directive
(89/336 EEC).
It must be installed by qualified person-
nel only.
The appliance must be installed in an
area which is not accessible to the pub-
lic.
WARNING! Always disconnect the
appliance from the mains supply before
starting any maintenance work and
before accessing any internal compo-
nents.
Follow all the precautions listed below.
They are essential to safety.
Check that the appliance has not been
damaged in transit. If any damage is visible,
report it to the carrier immediately.
Make sure that the voltage and frequen-
cy of the mains electricity supply corre-
spond to the specifications on the appli-
ance. Also make sure that the mains sup-
ply has sufficient installed power for the
appliance to operate simultaneously with
any other electrical appliances that might
be connected to the same power line.
To avoid fire, explosion and injury, never
operate the appliance in the presence of
dangerous substances or near appliances
that produce naked flames.
In particular make sure that the appli-
ance is efficiently earthed.
The system must be connected to the
mains electricity supply in accordance with
the wiring diagram in the outdoor section
installation manual.
Make sure that the appliance is installed
in compliance with all applicable national
safety standards.
The appliance can only operate correctly
and without risk provided it has been
installed and tested by specialist person-
nel.
After installation, carry out functional test-
ing and instruct the user in the operation of
the system.
This manual describes the installation of
the indoor unit of a split system consisting
of two Carrier units. Coupling different
units equipped with different control sys-
tems can damage the systems and invali-
dates the respective warranties. The man-
ufacturer accepts no responsibility for sys-
tem malfunctions deriving from unap-
proved coupling.
The manufacturer declines all responsi-
bility for damage or injury caused by unau-
thorised modifications to the appliance or
incorrect electrical or coolant connections.
Failure to observe the instructions given
in this manual or use of the appliance in
conditions other than those specified in the
“Operating Limitations” table in the appli-
ance’s installation manual automatically
invalidates the warranty.
Only use the appliance for the purpose
for which it is intended. The indoor unit is
not suitable for use in washrooms.
• Do not use the appliance if it is damaged.
In the event of any malfunctioning, switch
the appliance off immediately and discon-
nect it from the mains electricity supply.
• Only qualified personnel are authorised to
clean inside or maintain the appliance.
• Arrange for periodic checks to be carried
out on the unit, the electrical connections,
the coolant pipes and the safety devices
(these operations must be carried out by
qualified personnel only).
This appliance contains moving parts.
Make sure that children cannot get at
them.
40DMC_GB_install.qxd 27-09-2005 8:49 Pagina 2

Other manuals for Carrier 40DMC

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Carrier 40DMC and is the answer not in the manual?

Carrier 40DMC Specifications

General IconGeneral
BrandCarrier
Model40DMC
CategoryAir Conditioner
LanguageEnglish

Related product manuals