No. Item Outline of specifications Remarks
8
Louver control
(Continued):
In COOL / DRY operation
Direct the louver (adjustment plate of up / down wind
direction) horizontally. If directing it downward, the dew
may form on the surface of the air discharge port and
may drop down.
In FAN operation
Select a desired louver direction.
How to start swinging
1. Push , set the louver (adjustment plate of
up / down wind direction) direction to the lowest
position, and then push
again.
SWING
is displayed and the up / down louver
direction is automatically selected.
Display during swinging
How to stop swinging
1. Push at a desired position while the louver is
swinging.
• When
is pushed after that, wind direction can
be set again from the highest position.
* However, even if
is pushed while the louver
is swinging, the louver position is displayed as
follows and highest position of the louver may not
be selected.
Display when swinging is stopped
In this case, push again two seconds later.
• In Cool / Dry operation, the louver does not stop
as it directs downward. If stopping the louver as it
directs downward during swing operation, it stops
after moving to the third position from the highest
position.
Display when stopping the swing
3) When the unit stopped or the warning was output, the
louver is automatically set to full closed position.
4) When self-cleaning is performed, the louver is
automatically set to horizontal discharge position.
* The louver which air direction is individually set or
the locked louver closes fully when the unit stops and
the louver is automatically set to horizontal discharge
position when self-cleaning is performed.
Initial setup
Initial setup
Repeat
Fan operation
Fan operation
Cool / Dry
operation
Cool / Dry
operation
To Next Page
Loading...
