Carrier 40TGV0481UP - Page 80

9-1-7. How to set louver lock (Louver fix)
1 Push (At the right side of the button)
for 4 seconds or more during stop of the
operation.
•
flashes
2 Push
(At the left side of the button)
and select the unit to be set.
• Every pushing the button, the unit No. changes.
UNIT No.
1–1
UNIT No.
2–1
UNIT No.
3–1
UNIT No.
4–1
The fan of the selected unit rotates and the louver
swings.
3 Push temp. set
/ to display the louver
No. of which air direction is to be fixed.
• The selected louver swings.
[F1] [F2] [F3] [F4]
4 Push / and select air
direction of the louver of which swinging
you do not want.
0001 0002
0003
0005
0004
Code
* If selecting above , and …, there may be fear of
dewing in cooling time.
5 Push
to determine the setup contents.
• When the setup was determined, mark goes
on.
To set continuously the louver lock of the other
unit, repeat operations from 2 but from 3 to set
the other louver lock in the same unit,
respectively.
6 Push
to finish the setup.
0001 to 0005
(Louver fixed position code)
Louver
No.
* F1 displayed at the item code on the remote
controller means that the 01 louver was selected
as shown in the figure
04 02
03
01
Electric parts box
Refrigerant pipe
Drain pipe
NOTIFICATION
• Even if louver lock works, the louver temporarily
moves in the following cases.
1) During stop
2) During thermostat OFF
9-1-8. How to clear louver lock
In the item 4 of the louver lock setup procedure, set
the air direction to 0000.
•
mark goes off.
The operations from 1 to 3, 5
and 6 are same as those of the
louver lock.
9-1-9. How to set contents of save operation
1 Push
for 4 seconds or more during
stop of the operation.
•
flashes
2 Push (At the left side of the button)
and select the unit to be set.
• Every pushing the button, the unit No. changes.
The fan of the selected unit rotates and the
louver swings.
UNIT No.
1–1
UNIT No.
2–1
UNIT No.
3–1
UNIT No.
4–1
3 Determine the capacity restricted value when
pushing the save button of
/ .
• Every pushing the button, the capacity restricted
value can be set at 1% interval in the range
between 100% and 50%.
* The setting at shipment is 75%.
Setup value at saving
4 Push and then push to finish the setup.
Code 0000
- 80 -