Power ON
“SETTING”
flashes
“SETTING”
goes out
Remote
controller
is available
Approx. 5 minutes
Power ON
“SETTING”
flashes
“SETTING”
goes out
Remote
controller
is available
Approx. 1 minute
7 When installing indoor unit on high ceilling
REQUIREMENT
• When you use this air conditioner for the first time, it takes approx. 5 minutes until the remote controlle
becomes available after power-on. This is normal.
<When power is turned on for the first time after installation>
It takes approx. 5 minutes until the remote controller
becomes available.
<When power is turned on for the second (or later) time>
It takes approx. 1 minute until the remote controller
becomes available.
• Normal settings were made when the indoor unit
was shipped from factory. Change the indoor unit settings as required.
• Use the wired remote controller to change the settings.
* The settings cannot be changed using the wireless remote controller, sub remote controller, or
remote controllerless system (for central remote controller only).
Therefore, install the wired remote controller to change the settings.
■ Changing of settings of for applicable controls
Basic procedure for changing settings
Change the settings while the air conditioner is not working.
(Be sure to stop the air conditioner before making settings.)
Procedure 1
Push button and temp. setup button
simultaneously for at least 4 seconds.
After a while, the display flashes as shown in the
figure. Confirm that the CODE No. is [01
• If the CODE No. is not [01], push
button to
erase the display content, and repeat the procedure
from the beginning.
(No operation of the remote controller is accepted for
a while after button is pushed.)
Procedure 2
Each time you push
button, indoor unit
numbers in the control group change cyclically.
Select the indoor unit you want to change settings for.
The fan of the selected unit runs. You can confirm th
indoor unit for which you want to change settings.
Procedure 3
Using temp. setup / buttons, specify CODE
No. [
].
Procedure 4
Using timer time
/ buttons, select SET DATA
[ ].
Procedure 5
Push
button. When the display changes from
flashing to lit, the setup is completed
• To change settings of another indoor unit, repeat
from Procedure
2.
• To change other settings of the selected indoor unit,
repeat from Procedure
3.
Use button to clear the settings.
To make settings after button was pushed, repeat
from Procedure 2.
Procedure 6
When settings have been completed, push button
to determine the settings.
When button is pushed, “SETTING” flashes an
then the display content disappears and the air
conditioner enters the normal stop mode.
(While “SETTING” is flashing, no operation of th
remote controller is accepted.)
(* Display content varies with the indoor unit model.)
To Next Page
Loading...
