Carrier 50HJ015 - Page 4

CONTROL 80X
ACCE55
f (8?)
25% AIR OR
ECONOMIZER HOOD
U
FIELD--
SUPPLIED
u
1
O' -3"
(76)
3 7/16*
SECTION A-A
0 -3 7/8
(99)
II
INDOOR COIL
ALTERNATE RETURN
3/4" FPT ORA IN CONNECTION
(27) FAR 5IDE ONLY
DIMENSIONS
-3* 8 7/8'DIA CONCENTRIC < 0
(76) £ (22) (FIELD POWER)
UNIT
A
B C
50HJ
Ft-in. mm Ft-in. mm
Ft-in. mm
015 3-0
914 2-9 838 1-10 559
024 3-4% 1035
3-7
1092 1-8 508
LEGEND
KO — Knockout
NOTES:
1
CORNER WEIGHT*
UNIT
50HJ
A
1_ B _1
C j
D
Lb
Kg
Lb
Kg
Lb
Kg
Lb
Kg
015 390
177
243 110 322 146
515 234
024 492 1
233
511
232
504
229 523 237
‘Weights are for unit only (with aluminum evaporator and condenser
coil fins) and do not include options or crating
Dimensions in ( ) are in millimeters
2 ® Center of gravity.
3<=> Direction of airflow.
4 Ductwork to be attached to accessory roof curb only.
5. Minimum clearance:
a Rear: 7'-0" (2134) for coil removal. This dimension
can be reduced to 4'-0” (1219) if conditions permit
coil removal from the top
b Left side: 4'-0" (1219) for proper condenser coil
airflow
c Front 1 4'-0" (1219) for control box access
d. Right side: 4'-0" (1219) for proper operation of damper
and power exhaust (if so equipped).
e. Top: 6'-0" (1829) to assure proper condenser fan
operation.
f. Local codes or jurisdiction may prevail.
6. With the exception of clearance for the condenser coil
and the damper/power exhaust as stated in note no 5, a
removable fence or barricade requires no clearance
Dimensions are from outside of corner post. Allow
0'- 5 /ie" (8) on each side for top cover drip edge
7.
Fig. 4 — Base Unit Dimensions
4