41
PC or MAC. Install the software on your computer, then go to the Menu and select Photo
Export. Follow the instructions on-screen in the PC application.
• Touch the upload photo icon on the menu screen on the Infinity System Control.
• Place the micro SD card into the micro SD card port on the bottom of the Infinity System
Control when prompted.
• The Control will automatically upload the photo.
• Once complete, you will receive a confirmation that your photo is loaded.
• After you have selected your desired reminders, touch SAVE.
15. Heat Source (If Applicable)
With the Infinity System Control, you can select the desired heat source of your system, if your
system is equipped as a HYBRID HEAT® System. Select the HEAT SOURCE icon from the
menu screen.
A170239C
NOTE: Options available on this screen will correspond to the equipment attached. Options
may appear that are different than those shown, below.
• The default is for the system to Control the heat source.
• To have only the furnace Control, select FURNACE ONLY.
• To have only the heat pump, select HEAT PUMP ONLY.
• To have only electric select ELECTRIC ONLY.
• When you have made the appropriate selection, touch SAVE.
16. Zone Names (If Applicable)
With the Infinity System Control, you have the ability to customize zone names. Select the
ZONE NAMES icon from the menu screen.
A170240C
To Next Page
Loading...
