Carrier i-Vu XT - Page 29

i-Vu® XT Router (drv_gen5) CARRIER CORPORATION ©2022
Installation and Start-up Guide 25 All rights reserved
BACnet/SC Port tab
NOTE Because BACnet/SC runs on your IP network, you must configure the router’s IPv4 or IPv6 address
information on the Gig-E Port tab. If the router will not be routing to IP devices, you can Disable those ports after
configuring them.
The Connections > BACnet/SC Port tab provides hub status information plus the ability to configure the items
described in the table below for up to two Secure Connect ports.
Network Number
Specify a number for the BACnet/SC network or set to 0 if the port is not used.
The network number is 0 by default.
NOTE When downloaded from the i-Vu® application, these numbers match those
set using SiteBuilder.
Address
The Virtual MAC address of the router on the BACnet/SC network. It is the hex
representation of the Device Instance found on the Connections > Device tab.
NOTE If the Device ID of the router is zero (not recommended), a ’01’ will be
assigned to the third octet of this address because zero addresses are not valid
on a BACnet/SC network.
Connection State
The status of the router’s connection as a client on the BACnet/SC network.
Primary Hub URI
Web address used to connect to the primary hub.
NOTE If you must use a proxy to reach the hub, enter proxy information on the
Advanced > Network tab.
Primary Hub Status
The state of the primary hub communication.
Failover Hub URI
Web address used to connect to the optional failover hub.
NOTE If you must use a proxy to reach the hub, enter proxy information on the
Advanced > Network tab.
Failover Hub Status
The state of the failover hub communication.
Advanced
Is Failover Hub?
Indicates if being used as a failover hub.
NOTES
• A router can serve as a failover hub, but not as a primary hub. A supported
BACnet/SC network requires a virtual or cloud-hosted hub to be used as the
primary BACnet/SC hub.
• Using a router as a failover hub is supported for up to 10 BACnet/SC
router connections. For BACnet/SC networks with more than 10
router connections, purchase an additional BACnet/SC Virtual Hub to use as
a failover hub.
Listening Connection Type
When set as a failover hub, select interface type used to listen for connections.
Server Port
When set as a failover hub, enter the port on which the hub will be listening.
URIs
When set as a failover hub, this is the web address used by network devices to
connect to the hub. The URI is derived from the IP Port configured on the
Connections > Gig-E Port tab.
Minimum Reconnect Time
Initial number of seconds to wait before retrying a connect to a hub which
increases with each failure.
Maximum Reconnect Time
Maximum number of seconds to wait between connection retries to a hub.