Why is there excessive communication errors on Carrier i-Vu XT Router Network Router ARCNET/MSTP?
Excessive communication errors on ARCNET/MSTP may occur if the network cable is not properly connected, or if the baud rate is incorrect. Ensure that the network cable is securely connected and that the baud rate is set correctly.
What to do if no other devices detected on Carrier Network Router ARCNET/MSTP?
If no other devices are detected on ARCNET/MSTP, verify that the network cable is properly connected and that the baud rate is correct.
What to do if Carrier Network Router has an Ethernet connection problem?
If you are experiencing an Ethernet connection problem, connect the Ethernet cable. Also, check other network components to ensure they are functioning correctly.
What to do if Carrier i-Vu XT Router experiences Event System Error - FPGA RX FIFO full?
If you encounter an Event System Error indicating that the FPGA RX FIFO is full, check the network configuration for a circular route. Additionally, increase the time between COVs to reduce excessive COV traffic.
What to do if Carrier i-Vu XT Router default IP address mismatch?
To resolve a default IP address mismatch, use the controller setup Ports tab to set the IP address. Then cycle the power to accept the new IP address. Alternatively, change the rotary switches to match the current default IP address.
What to do if Carrier i-Vu XT Router experiences Auto restart delay due to system error on startup?
If the Carrier Network Router experiences an auto restart delay due to a system error on startup, allow the 5-minute delay to expire. If the condition occurs again after the delay, cycle the power.
What to do if Carrier i-Vu XT Router has ARCNET/MSTP firmware error?
To address an ARCNET/MSTP firmware error, change the rotary switch to select a valid protocol and then cycle the power.
What to do if Carrier i-Vu XT Router Network Router has Duplicate address on ARCNET/MSTP?
If there is a duplicate address on ARCNET/MSTP, change the rotary switch to a unique address.
What to do if Carrier i-Vu XT Router has Invalid address selection for ARCNET/MSTP?
If there is an invalid address selection for ARCNET/MSTP, change the rotary switch to a valid address.
How to fix BACnet/IP error on Carrier i-Vu XT Router?
To resolve a BACnet/IP error, cycle the power.
General| Manufacturer | Carrier |
|---|---|
| Model | i-Vu XT Router |
| Category | Network Router |
| Protocols | BACnet/IP, BACnet MS/TP |
| Ethernet Ports | 2 |
| MS/TP Ports | 1 |
| Power Supply | 24 VAC |
To Next Page
