Carrier i-Vu XT Router - Advanced Tabs; Security Tab

i-Vu® XT Router (drv_gen5) CARRIER CORPORATION ©2022
Installation and Start-up Guide 29 All rights reserved
Advanced tabs
Security tab
Configuration Access
Disable Service Ports
When checked, disables all communication through the Service Port. You can only
configure the i-Vu® XT Router in the i-Vu® application or Field Assistant by using
BACnet/IP.
Allow Configuration on
Service Port
Enables access to the controller setup pages through the Service Port.
Allow Configuration on Gig-E
Port
Enables access to the controller setup pages through the network that the Gig-E
Port is connected to. See Connecting to the router through the Gig-E Port.
NOTE You must first set a password in the i-Vu® application.
BACnet Whitelist for Gig-E
Enable BACnet Whitelist
Check to enable. The list of IP addresses displayed on the page are the IP
addresses the device is allowed to communicate with. Must include the server IP
address.
Enable Private IP Ranges
Restricts communication with the router to all private IP addresses.
IPv4
Lists of Ipv4 ranges that can be used in whitelisting
IPv6
Lists of Ipv6 ranges that can be used in whitelisting
Whitelist
Enable Custom Range
Whitelist
Check to enable.
Address Ranges
Click Add to enter information or Delete to remove existing information.