Carrier i-Vu XT - Page 6

i-Vu® XT Router (drv_gen5) CARRIER CORPORATION ©2022
Installation and Start-up Guide 2 All rights reserved
The i-Vu® XT Router has 4 physical BACnet communication ports:
Port
Port type
For routing this type
of communication...
At...
Gig-E
10/100/1000 Mbps Ethernet
BACnet/IP
BACnet/Ethernet
10, 100, or 1000 Mbps (1
Gbps)
S1
High-speed EIA-485 port
BACnet/ARCNET
BACnet/MSTP
156 kbps
9.6 to 115.2 kbps
S2
Electrically isolated EIA-485 port
BACnet/MSTP
9.6 to 115.2 Kbps
Service
Port
10/100 Mbps Ethernet
HTTP/IP
BACnet/IP Service Port
10 or 100 Mbps
i-Vu® XT Router also has a USB port for recovery.
Critical Product Announcement
Due to the global semiconductor supply chain uncertainty, starting July 2022, the i-Vu® XT Router will no longer
support communication over the ARCNET network. ARCNET-disabled i-Vu® XT Router routers have a serial number
starting with the prefix RT4 and have an updated label. See To get the i-Vu® XT Router's serial number (page 38).
The i-Vu® XT Router's driver properties and controller setup pages only show available communication selection
options.
Specifications
Driver
drv_gen5_< version >
NOTE For the fwex driver instructions, see the (part# i-Vu® XT Router) (drv_fwex)
Installation and Start-up Guide.
Power
24 Vac ±10%, 50–60 Hz, 50 VA
26 Vdc ±10%, 15 W
Gig-E port
10/100/1000 BaseT Ethernet port for BACnet/IP and/or BACnet/Ethernet
communication on the Ethernet at 10, 100, or 1000 Mbps, full duplex
Port S1
For communication with either of the following:
• A BACnet ARCNET network at 156 kbps
• A BACnet MS/TP network at 9600 to 115200 bps
This port's End of Net? switch can be set to Yes to terminate the network segment.