9 62-12002
6. Pre-Trip
Pre-Trip is a test sequence that the operator may initiate to check unit
operation. When Pre-Trip is enabled, the unit will enter a test sequence to
operate the unit in various operating modes.
1. Start and run the unit.
2. Press the Function key. “Pre-Trip N” will be enabled. Press the =
(Enter) key.
3. Press the up or down arrow until “Pre-Trip Y” is displayed. Press
the = (Enter) key to start the Pre-Trip.
The screen will display the status of the Pre-Trip test (“Test 1,”
Test 2,” etc.).
If the conditions for Pre-Trip are not met, the unit will not
enter Pre-Trip and the display will return to its default display
To Next Page
Loading...
