Carrier TP-WEM01 - Ideal Humidity System Technology (Standard Dehumidification + Super Dehumidification)

83 | P a g e
Ideal Humidity System
®
Technology
(Standard Dehumidification + Super Dehumidification)
This feature takes advantage of the intelligence within the Carrier equipment to
increase the dehumidification of the cooling cycle. When there is a demand for
cooling and not humidity, the system runs normal.
NOTE: Ideal Humidity System
®
Technology only works with Infinity
®
furnace / fan
coils and the FV fan coil.
Ideal Humidity System
®
Technology consists of 3 unique modes to remove humidity:
1) Standard Dehumidification – Outlined above
2) Super Dehumidification – When there is a demand for dehumidification without a
demand for cooling, the thermostat will run the equipment in cooling mode at 50-
65% of cooling speed (dependent on the equipment).
3) SmartEvap™ – The blower will shut down within 5 seconds after a cooling cycle
to prevent re-evaporation of the water on the coil. When in continuous fan, the
blower will start again after 5 min.
NOTE:
 Some equipment has a time limit on Super Dehumidification operation.
 When Super Dehumidification is enabled, this feature cannot be
overridden by changing the Cool to Dehumidify to 0
o
F.
WARNING! Super Dehumidification may cause the system/duct work to sweat in
some unconditioned installations in high humidity areas.