Carrier Transport Air Conditioning - In-Wall Evaporator Cut-Out and Wiring; CAUTION: Cutting Rails and Harnesses; Insulation and Wiring Management

T--311
2-- 17
Figure 2-37 In-Wall Cut-Out (Panel Removed)
CAUTION
When installing any IW unit, be careful not to cut the bus structure rails or wiring harnesses.
Figure 2-38 In-Wall Cut-Out (Insulation Removed)
Bracket To Hold Wiring Up
Left Structure Rail
Right Structure Rail
Figure 2-39 In-Wall Cut-Out (Wires Supported)
e Carefully remove the insulation from between the
walls. Nothing should interfear with the In-W all
evaporator. Move the wiring to the top of the cut-out and
support in place (See Figure 2-39).