T--311
4--6
Figure 4--17 Correct Hose/Harness Corner
Routing (Window Not Blocked)
T rim-Lock
Figure 4--18 Side-Mounted Routing (Top)
Figure 4--19 Hose/Harness/Drain Line Tie-W raped
To Hose Cover Backs
Insulated Clamp
Figure 4--20 Hose/Harness Clamped to W all
At this time the evaporator can be mounted. Refer to
Section 2 for the proper procedures for installing a rear
mounted evaporator assembly.
12.You may now make the appropriate connection to
the evaporator.
Proper hose to fitting clamping is critical. Do not attempt
to attach any hose or fitting until you have familiarized
yourself with Carrier Transport Air Conditioning
Quick-Click hose/fitting crimping procedures.
4.4 EVAPORATOR HOSE ROUTING, OUTSIDE
THE BUS WALL
The evaporator has been previously installed. Refer to
Section 2 for the proper procedures for installing a rear
mounted evaporator assembly.
To Next Page
Loading...
