Carrier WeatherExpert 50LC - Multi- -Speed VFD Display Kit (Field- -Installed Accessory)

49
C13110
Fig. 54 -- Variable Frequency Drive (VFD)
Variable
Frequency
Drive (VFD)
Filter - used on
575V units only!
C13111
Fig. 55 -- VFD Location
Multi--Speed VF D Display Kit
(Field-- Installed Accessory)
NOTE: The Remote VFD Keypad is part of the
Multi--Speed VFD display kit (PN: CRDISKIT002A00)
which is a field--installed accessory. It is not included with
the 50LC 07 base unit.
The VFD keypad as shown in Fig. 56 consists of the
following sections:
O
Reset
Hand
On
Alarm
Warn.
On
Com.
OK
B
a
c
k
Auto
On
Status
Menu
Quick
Menu
Main
Menu
1-20 Motor Power
[2] 0.12KW-0.16HP
Setup 1
ALPHA
NUMERIC
DISPLAY
MENU KEY
NAVIGATION
KEYS
AND
STATUS
LEDs
OPERATION KEYS & LEDs
C13112
Fig. 56 -- VFD Keypad
Alpha Numeric Display: The LCD display is back lit with
2 alpha--numer ic lines. All data is display ed on the LCD.
1-20 Motor Power
[2] 0.12KW-0.16HP
Setup 1
1
3
2
4
5
C13113
1 Parameter numbe r and name.
2 Parameter value.
3 Setup number shows the active se tup and the edit
setup. If the same set--up acts as both the active
and edi t set--up, only that setup number is shown
(factory setting). When the active and edit setup
differ, both numbers are shown in the display
(SETUP 12). The flashing number indicates the
edit setup.
4 The symbol in the number 4 position in the figure
above indica tes motor direction. The arrow point
either clockwise or counter--clockwise to show the
motor’s curre nt direction.
5 The pos ition of the triangle indicates the curr ently
selected menu: Status, Quick Menu or Main Menu.
Menu Key: Use the Menu key to s elect between Status ,
Quick Menu or Main Menu. The triangle icon at the bottom
of the LCD display indicates the currently selected mode.
(See number 5 in the table above.)