Carrier WeatherExpert 50LC - Page 55

55
10. Setting Digital Inputs:
a. Press the Back key until the following display
appears --
3---** Reference / Ramps
4--- ** Limits / Warnings
b. Press B(Down Arrow) once, the followin g
display appears --
4--- ** Limits / Warnings
5 --- * * D i g i t a l I n / O u t
c. Press OK, the following display appears --
5 --- 0 * D i g i t a l I / O m o d e
5---1* Digital Inputs
d. Press B(Down Arrow) once to move the high-
light to the bottom row and then press OK.The
following display appears --
5-10 Terminal 18 Digital In…
[8] Start
e. Press B(Down Arrow) again. The following
display appears --
5-11 Terminal 19 Digital In…
[16] Preset ref bit 0
f. Press B(Down Arrow) again. The following
display appears --
5-12 Terminal 27 Digital In…
[17] Preset ref bit 1
g. Press B(Down Arrow) again. The following
display appears --
5-13 Terminal 29 Digital In…
[18] Preset ref bit 2
NOTE: By pressing OK the number in the bracket can be
change d until the desired number appears. Press OK again
to set the selected value.
11. Setting Analog Inputs:
a. Press the Back key until the following display
appears --
4--- ** Limits / Warnings
5 --- * * D i g i t a l I n / O u t
b. Press B(Down Arrow) until the followin g display
appear s --
5 --- * * D i g i t a l I n / O u t
6 --- * * A n a l o g I n / O u t
c. Press OK, the following display appears --
6 --- * * A n a l o g I n / O u t
6 --- 1 * A n a l o g I n p u t 5 3
d. Press B(Down Arrow) once to move the high-
light to the bottom row and then press OK.The
following display appears --
6-10 Terminal 53 Low Voltage
2V
e. Press B(Down Arrow) once to move the high-
light to the bottom row and then press OK.The
following display appears --
6-11 Terminal 53 High Voltage
[10V]
f. Press B(Down Arrow) once to move the high-
light to the bottom row and then press OK.The
following display appears --
6-14 Set Min Reference
[0 Hz]
g. Press B(Down Arrow) once to move the high-
light to the bottom row and then press OK.The
following display appears --
6-15 Set Max Reference
[60 Hz]
12. Setting Reset Mode and RFI Filter:
a. Press the Back key until the following display
appears --
0 --- * * O p e r a t i o n / D i s p l a y
1---** L oad and Motor
b. Press B(Down Arrow) until the followin g display
appear s --
1 3 --- * * S m a r t L o g i c
1 4 --- * * S p e c i a l F u n c t i o n s
c. Press OK, the following display appears --
14---0* Inverter Switching
14---1* Mains On/Off
d. Press B(Down Arrow) twice. The following
display appears --
14---1* Mains On/Off
14--- 2* Reset Functions
e. Press OK, the following display appears --
14-20 Reset Mode
[0] Manual reset
f. Press OK to highlight t he num ber in the bracket.
g. Use the Y and B (Up and Down Arrow)keys
to change the number to 3 for 3 automatic resets
andthenpressOK. The display changes to --
14-20 Reset Mode
[3] Automatic reset x 3