4
ENGLISH
Occupancy
Louver Position
To optimise energy efciency of the
building while preserving its occupants
comfort, the controller is scheduled
according to occupancy hours.
You can set the room occupancy
manually if the scheduled program does
not match the current occupancy status
of the room.
For cassette fan coils with motorised
louvers, it is possible to control the
direction of the air ow by adjusting the
louver position.
1 to 6 xed positions.
Automatic: Louver position is set
automatically.
Position 1 in Heating mode:
The heated air is directed to the oor
level.
Position 6 in Cooling mode:
The cooled air is distributed near the
ceiling.
Swing: Louvers keep oscillating from
the top downwards for better air
distribution.
To set room occupancy
■ Press the Menu button repeatedly
until the Occupancy screen appears.
■ Press the Up button or the Down
button to set the room occupancy to
ON or OFF.
■ When the room occupancy is set, press
to go to the next screen or wait 10
seconds to go back to the default
screen.
To set the position of louvers
■ Press the Menu button repeatedly
until the Louver screen appears.
Occupied
Louver position: 1
Unoccupied
Louver position:
Swing
Example:
■ Press the Up button or the Down
button to set the position of louvers.
Automatic
X
Fixed position (P1 to P6)
x = position number
Swing
■ When the louver position is set, press
to go to the next screen or wait
10 seconds to go back to the default screen.
Note: Louver position can be adjusted only
when the status of the room is occupied.
To Next Page
Loading...
