Carrier WTC-RCI-DC Series - Lighting Control Operations; Setting and Controlling Lights

5
ENGLISH
Lighting Control
To set the lights
■ Press the Menu button repeatedly
until the Lights screen appears.
■ Press the Up button or the Down
button to select the lighting group
number.
Example:
Selecting one zone (zone number
displayed).
DIMMING
UP: Lights dimming up.
STOP: Lights control stopped.
DOWN: Lights dimming down.
STOP: Lights control stopped.
Lighting group
No. 8 controlled
All lighting groups
controlled
Selecting all zones (ALL means that all
lighting groups will be managed at the
same time).
■ Once the lighting group is selected,
press to access the command for
the lights.
■ Press or to set the lights command.
ON/OFF
ON: Lights ON.
OFF: Lights OFF.
■ When the lighting is set, press to go
to the next screen or wait 10 seconds to
go back to the default screen.
Note: If your installation uses gradual
lighting, UP and DOWN commands can be
used to increase and decrease your indoor
lighting (see DIMMING).
■ When the lighting is set, press
to go to the next screen or wait
10 seconds to go back to the default
screen.