20
Fresh air unit
⑬Contents, Click on the switch "Buildings/Floors/Groups"
⑭ Device/partition display
3.2.2 Device monitor - list mode
The monitor interface has a list mode in addition to the icon display interface , You can view setup
information and troubleshooting. All devices" cannot be selected in list mode. Only one of the devices
IDU/fresh air /HRV" can be selected for monitoring.
The following picture shows the monitoring interface of list mode
① Device name, display the current device name
② Mode of the device, display the operating mode of the device
③ Ambient temperature, the display range is -30-80℃
④ Current set temperature, set temperature range 16-30℃
⑤ Display the current set wind speed
⑥ Shows the current centralized control mode
⑦ Displays the machine that sets the timing mode
⑧ Shows the current fault code, fault code 0 means the equipment no fault
⑨ unit address
① ② ③ ④
⑤
⑥ ⑦
⑧
⑨
To Next Page
Loading...
