44
③ Automatic online button，Click “ ”， to enter the automatic on-line process. Nothing else can be done
while the device is executing. After the on-line completion, it will automatically generate all the indoor units
that are currently on-line, but will not automatically delete the devices that are not currently on-line.Device
deletion can only be done manually.
④ Edit button，Click the device to enter the device editing interface. The device that has been generated
and saved can only modify specific parameters.
"Device Type/Device model/Bus Address. Gateway address/Device address" cannot be modified
3.8 Partition setting
Partition Settings are used for device partition management and are divided into three levels
“building”， A completed building, such as an office building. Each building may contain several floors
“floor”， Refers to a floor in a building, each floor may contain several zones
“zone”， zones refers to the sub-division under the floor level, and each zones can contain several devices
3.8.1 Building arrangement
① Name of the building, click the entry to select the current building, or click fold/Expand the building, Click
“ ” to expand details, click “ ” to fold details.
② Edit button
，Click add new building
，Click edit building name
，Click delete current building
①
②
To Next Page
Loading...
