88
4 webserver function
Webserver setting function. When the central controller is configured, users can connect the central
controller remotely and manage the device remotely through PC browser
Recommended display resolution: 1920*1080, too high or too low resolution may lead to functional display
dislocation
Compatible browser: Chrome 83 or above
4.1 Remote login address Settings
When webserver is used, network Settings and fixed IP addresses should be set first.Webserver cannot be
used if IP address is automatically obtained
Webserver function set use port: 8000
Access address: http:// Fixed IP address :8000/
For example（The following information is for reference only and can be modified as needed）：
Use LAN1 interface to access the network
IP address information
IP address: 192.168.1.100
Subnet mask: 255.255.255.0
Gateway address: 192.168.1.1
DNS Settings
Preferred DNS: 8.8.8.8
Alternative DNS Settings: 8.8.8.8
As shown in the figure below
Enter the network setting interface and select the access network type
After the setup is completed, the centralized controller can be remotely controlled by the computer.
To Next Page
Loading...
