53
3.12 Unit setting
The unit setting function is used to manage the external machine system and check the state parameters of
the external machine master and slave
The unit setting function is mainly used to manage the external machine. It can check the external machine
state quickly, lock the external machine mode and set the system load rate limit.
① External machine management, display the gateway information and gateway name. Click " " to edit
the name of the unit.
② Display the current version of the gateway
③ System mode setting, the system mode can be set as "single cold/single hot/unlimited".
Single cooling, the system only responds to the cooling demand of the internal machine, and different
modes are displayed when the internal machine sends out the heating mode
For single heat, the system only responds to the heating demand of the internal machine, and different
modes are displayed when the internal machine sends out the refrigeration mode
Unlimited. The system responds to the internal machine's refrigeration or heating requirements. The system
mode is based on the first internal machine turned on in the current system.The system load rate limit, can
limit the system operation of the maximum load rate, the limit value for the system
①
② ③
④
⑤
⑥
⑦
To Next Page
Loading...
