26
HRV monitoring display is similar to IDU monitoring display, but the details are different, as shown in the
figure below.
① Full on/full off , Click full on or full off to turn all HRV on or off
② Device name, display the current device name
③ Display the operating parameters of the current equipment, including "centralized address/mode/indoor
temperature/outdoor temperature/wind speed", etc
④ central control
⑤ When the number of timed tasks is not 0, click to view the current schedule details
⑥ When the number of failures is not 0, the current failure status can be viewed by clicking
Choose Fresh Air". The display interface is similar to the indoor units monitoring, but the details are different,
as shown in the figure below.
①
②
③
④
⑤ ⑥
To Next Page
Loading...
