Carrier XCT 7 40VCC727FQEE - Timed Action Editing and Management; Edit Timer Action Interface; Air Conditioner Timed Action

61
3.13.4 Edit timer action
A timed action is used to set control instructions to be given to the designated device at a specific time.
After selecting the timer task, you can query the timer action by switching tabs, as shown in the figure below
① Click "+" to add a new timer task
② Click the corresponding item to mark it in the popover
③ Timing action type, timing action can be switched to "air conditioning/full heat/fresh air"
3.13.5 Timed action of air conditioner
The air conditioning timed action popover is as follows. You can set "Device type/Effective/Invalid/action
name/timing time/timing device/Timing details".
① Type of equipment, click the type of equipment corresponding to the switching timing task, you can
switch to "air conditioning/Full heat/fresh air"
② Whether it is effective, click switch. When the timed action is effective, the control instruction is issued
when the trigger time is met; when the setting is invalid, the control instruction is not issued
③ Action name, set timing action name, name repetition is not allowed under the current label
④ Timing time, the "time/minute" triggered by the timing action can be set by sliding.
①
②
③
①
②
③
④
⑤
⑥
⑦
⑧