Carson CV-10 NEW GENERATION User Manual

18
GB
CV-10 NEW GENERATION
Steering servo
Tools Needed for the Assembly
Scissors 30 001 3305Needle nose pliers 30 007 4034
Side cutter 30 007 4035
Modelling knife 30 007 4053
Hexagonal wrench 30 001 3118Philips screwdriver (small and big)
and hex-wrench
1.5/ 2 / 2.5 mm 30 007 4023
Instant adhesive 30 005 3339
Tweezers 30 007 4003
Please read the instructions provided with your radio system before
using it.
The servos must be set at the centre position before installation. To set
the servos at a neutral position, turn on the transmitter and receiver.
Set the trim levers in the centre position and turn off the receiver, and
then the transmitter. The servos will be in proper neutral position for
installation.
Receiver antenna
Batteries for receiver
Engine throttle
servo
Switch
a. Your Radio System (only for RTR version)
s
ion
)
Transmitter

Carson CV-10 NEW GENERATION Specifications

General

Brand	Carson
Model	CV-10 NEW GENERATION
Category	Toy
Language	English