CAS LP 1.6 Series - Programming the Adjust Number (SET #5); Programming the Printing Information (SET #6)

43
42
How to program the adjust number
1) To go to PROGRAM mode press 10000 by using numeric keys and VOID key.
2) Press
key five times.
3) The WEIGHT display shows “SEt”.
4) Press PRT/* key, “SEt EntEr”.
5) Press “5” key and PRT/* key.
6) The display shows “AdJSt EntEr 30 ”.
7) Type the new adjust value by pixel unit on the Numeric keypad. (1mm/8pixel )
8) Press PRT/* key. The display shows “FEEd EntEr 60 ”.
9) Type the new feed value by pixel unit Numeric keypad. (1mm/8pixel )
10) Press PRT/* key. The display shows “SEt”.
11) If you wish to finish PROGRAM mode press C key
4.7.5 Programming the Adjust Number (SET #5)
- ADJUST is to adjust the position of label.
- FEED is to feed label(or receipt).
4.7.6 Programming the Printing Information (SET #6)
The printing information controls the label size, PLU item description and barcode format.