CAS LP 1.6 Series - Programming Address (SET #8); Programming Baud Rate (SET #9)

47
46
How to program address
1) To go to PROGRAM mode, press 10000 by using numeric keys and VOID key.
2) Press
key five times.
3) The WEIGHT display shows “SEt’.
4) Press PRT/* key, “SEt EntEr”.
5) Press 8 key and PRT/* key.
6) The display shows “Addr EntEr 0”.
7) Enter address number by using numeric keys.
8) Press PRT/* key. The display shows “SEt”.
9) If you wish to finish PROGRAM mode, press C key.
4.7.8 Programming Address (SET #8)
Address means the ID of the scale when you network scales. The address can be from 0 to 99,
How to program baud rate
1) To go to PROGRAM mode, press 10000 by using numeric keys and VOID key.
2) Press
key five times.
3) The WEIGHT display shows “SEt”.
4) Press PRT/* key, “SEt EntEr”.
5) Press 9 key and PRT/* key.
6) The display shows “bAUd EntEr 3=9600”.
7) Look at table below and type number that you want.
8) Press PRT/* key. The display shows “SEt”.
9) If you wish to finish PROGRAM mode, press C key.
4.7.9 Programming Baud Rate (SET #9)
<RS232c Baudrate>
‘1’ = 2400bps
‘2’ = 4800bps
‘3’ = 9600bps
‘4’ = 19200bps
‘5’ = 38400bps
‘6’ = 57600bps