CAS NC-1 - Page 50

51
Err 11 (at Span calibration)
■ Cause
The weight for span calibration is greater than 100% of the maximum capacity.
■ Management
The weight for span calibration should be within 10~100% of the maximum
capacity in ‘BAL’.
Err 12 (at Span calibration)
■ Cause
The weight for span calibration is lower than 10% of the maximum capacity.
■ Management
The weight for span calibration should be within 10~100% of the maximum
capacity in ‘BAL’.
Err 13 (Zero Range when the Power is ON)
■ Cause
The initial zero range exceeds above 10% of maximum capacity
■ Management
Unload the scale
Check the A/D value (at ‘TEST 3’).
If the load cell is damaged, replace the load cell
Err 14 (at Span calibration)
■ Cause
The weight for span calibration is 0kg.
■ Management
The weight for span calibration should be within 10~100% of the maximum
capacity in ‘BAL’.
BAT or LobAt