5 - OPERATING INSTRUCTIONS
117
Stopping Combine Operation
1. Move the propulsion control lever to the
NEUTRAL position to stop the Combine
ground travel.
2. Raise the header using the header control
switch (1).
3. When the Combine has been cleared of all
material, move the feeder clutch switch (2) to
OFF. Move the separator drive switch (3) to
OFF.
4. Move the throttle hand lever (4) rearward to the
low idle speed position. Run the engine at low
idle speed for 3 to 5 minutes to permit the
engine and turbocharger temperature to
decrease gradually before stopping the engine.
A24307
RD00E065
1
A24293
3
2
A24303
4
To Next Page
Loading...
