4 - INSTRUMENTS/CONTROLS
42
A24294
1. REEL POSITION SWITCH - This is a four position switch which operates as follows:
Raise - Push the bottom of the switch to raise the reel.
Lower - Push the top of the switch to lower the reel.
Forward - Push the switch to the Left to move the reel forward (if equipped with the reel fore/aft
option).
Aft - Push the switch to the Right to move the reel to the rear (if equipped with the reel fore/aft
option).
2. HEADER CONTROL SWITCH - This is a four position switch which operates as follows:
Raise - Push the bottom of the switch to raise the header.
Lower - Push the top of the switch to lower the header.
Tilt Left - Push the switch to the left to tilt the header counterclockwise (Field Tracker® option).
Tilt Right - Push the switch to the right to tilt the header clockwise (Field Tracker® option).
3. GRAIN TANK UNLOADER TUBE SWITCH - Push the top of the switch to swing the unloader tube
out. Push the bottom of the switch to swing the unloader tube in. The middle position of the switch is
the Neutral position.
4. GRAIN TANK UNLOADER DRIVE SWITCH - To start the unloader, press the switch and then
release it. To stop the unloader press the switch.
NOTE: Refer to Rear Ladder Sensor in this section of the manual for additional information.
5. OPERATOR HAND REST
6. HAND REST ADJUSTING KNOB - The operator’s hand rest can be adjusted using the adjusting knob. To
loosen the adjusting knob turn it counterclockwise. Adjust the hand rest and retighten the adjusting knob.
NOTE: Field Tracker® is a registered trade mark of HCC, Inc.
6
3
2
1
4
5
To Next Page
Loading...
