4 - INSTRUMENTS/CONTROLS
67
INITIAL
DISPLAY
DESCRIPTION
ACTION
Enter Calibrate Mode. Push and hold and at the same
time. Turn the key switch ON.
Software revision level. Level momentarily displayed while holding
arrow keys.
Engine speed alarm set point.
Range is 1900 to 2700 RPM.
Push or
to increase or decrease the value.
Advance to next area. Push
Rotor speed alarm sensitivity. Range is 75 to 100. Push or
to increase or decrease the value by 5.
Advance to next area. Push
Set English or Metric. Push or
to select “E” or “M”.
Advance to next area. Push
Set tire size (if calibrated for English units)
OR
Push or
to increase or decrease the value (See Rolling
Radius Calibration Chart in this manual).
Set tire size (if calibrated for Metric units). Push or
to increase or decrease the value (See Rolling
Radius Calibration Chart in this manual).
Advance to next area. Push
Set low fuel warning at current gauge position,
OR
Push and
at the same time. Bars stop flashing.
To set representative numerical value of fuel level. Push and
at the same time.
Set low fuel warning level.
Range is 0 (minimum) to 52 (maximum.)
Push or
to increase or decrease the value.
Exit Calibrate mode at anytime. Push and
at the same time.
To Next Page
Loading...
