4 - INSTRUMENTS/CONTROLS
51
Floor Controls
A24286
1. FOOT-N-INCH PEDAL - This pedal is used to engage the drive to the wheels (pedal fully up) or to disengage
the drive to the wheels (pedal fully down).
NOTE: The propulsion control lever must be in the forward or reverse slot in order for the Foot ‘N Inch pedal to
start the Combine in motion. If the propulsion control lever is in the NEUTRAL position, the Combine will not move.
The Foot ‘N Inch pedal can be used to control inching, very slight movement of the Combine, by raising the pedal a
small amount from the full down position. When the Combine starts to move, pushing the Foot-N-Inch pedal fully
down will disengage the drive to stop forward movement.
NOTE: DO NOT use the Foot ‘N Inch pedal to allow the Combine to coast downhill. DO NOT depress the pedal
when at transport speed.
2. STEERING COLUMN TILT PEDAL - To move the steering column to another position, push the tilt pedal and
move the column. To lock the steering column in the selected position, release the tilt pedal.
3. BRAKE PEDALS - The Left pedal stops the Left drive wheel and the Right pedal stops the Right drive wheel.
For Left or Right turning, use the pedals separately. For safe operation on roads the Brake latch (4)
MUST be engaged.
4. BRAKE LATCH - The brake latch can be used to lock both brake pedals together so both pedals can be
actuated easily at the same time. Make certain the latch is fully engaged in the slot provided when
it is latched.
WARNING: The Brake Latch is used to lock both Brake Pedals together. Brake Pedals must be locked
together for road travel. This will insure uniform brake application and maximum stopping ability.
M112B
4
1
3
2
!
To Next Page
Loading...
