Case IH AXIAL-FLOW 2577 - Page 133

5 - OPERATING INSTRUCTIONS
119
HEADER CONTROLS
There are two modes to controlling the header height: (1) Manual and (2) Automatic. In the Automatic mode there
are three types of control: (1) Return to Cut; (2) Auto Height and (3) Auto Float.
Manual Position Control
Positioning the Mode Select switch to MANUAL Mode (“M”) will provide for manually raising/lowering the Header.
To operate the Combine in the MANUAL MODE
select “M” (1).
To raise or lower header use the HEADER
CONTROL SWITCH (2) on the propulsion control
lever.
The rate at which the header will raise is controlled
by the HEADER RAISE RATE CONTROL (3). The
rate at which the header will lower is controlled by
the HEADER LOWER RATE CONTROL (4). To
increase the rate at which the header raises or
lowers, turn the HEADER RAISE RATE CONTROL
and/or the HEADER LOWER RATE CONTROL to
the right (clockwise). To decrease the rate at which
the header raises or lowers, turn the HEADER
RAISE RATE CONTROL and/or the HEADER
LOWER RATE CONTROL to the left
(counterclockwise).
A24293
1
RD00E065
2
RD97G033
4
3