Case IH AXIAL-FLOW 2577 - Page 169

6 - FIELD OPERATION
155
M. Distribution Heavy on Right Side
1. Add Filler to Right of First Concave
2. Add, Remove or Adjust Auger Bed Paddle
3. Decrease Rotor Speed
4. Close Concave
5. Decrease Forward Travel Speed
N. Distribution Heavy on Left Side
1. Remove Fillers from Right of First Concave
(if installed)
2. Open Concave
3. Decrease Rotor Speed
4. Increase Rotor Speed
5. Add, Remove or Adjust Auger Bed Paddle
6. Remove Some Wires from Concaves
7. Decrease Forward Travel Speed
8. Inspect Concave for “zero” at 12th Bar of the
Concave