9 - MAINTENANCE/ADJUSTMENTS
408
Grate Removal
8. Remove the cover panel on the left side of the
Combine.
9. Remove the four (4) bolts and nuts that
connect the three grates.
10. Remove the three (3) bolts and nuts that hold
the center grate to the rotor cage.
11. Remove the center grate. The center grate
must be removed from the Combine first to
allow clearance for removing the other two
grates. Repeat Steps 10 and 11 to remove the
front and rear grates.
NOTE: The front grate is held to the rotor cage by
four bolts and nuts.
WARNING: Before setting the concave gauge, adjusting the concaves or removing concaves and rear
grates, put all levers in neutral, set the parking brake and shut OFF the engine. Remove the key from the
key switch.
M189B
!
A1895
A1899
To Next Page
Loading...
