9 - MAINTENANCE/ADJUSTMENTS
416
Tools required: 9/16 inch Wrench and Flat-Bladed
Screwdriver.
2. The brush bristles should poke evenly through
the rotary air screen holes - approximately 1 to 2
mm (3/64 to 5/64 inch) (A) along the rotary air
screen, as shown in the illustration. Adjust the
position of the rotary brush in the swing plate slot
to achieve an even distribution.
A. Hold the shaft (1) using the Screwdriver,
while loosing or tightening the 3/8 inch nut.
B. Adjust UP or DOWN position (2) on the
brush shaft in slot.
IMPORTANT: Rotate the rotary air screen 360
degrees. the rotary brush should stay in contact with
the screen at all times.
RR06B006
RR06B005
A. 1 TO 2 mm (3/64 TO 5/64 INCH
1. BRUSH SHAFT
2. ADJUSTING POSITION
A
A
1
2
To Next Page
Loading...
