4 - INSTRUMENTS/CONTROLS
54
6. KEY SWITCH - This switch has four positions:
A. OFF POSITION - The key is in the vertical
position. The Combine cannot be started
without the key. The key can only be
removed in the OFF position.
B. ACCESSORY POSITION -
Counterclockwise from the OFF position.
Use this position to operate the radio,
optional AFS system, etc. without engaging
the instruments or starting the engine.
C. ON POSITION - First position clockwise
from OFF. All warning lamp indicators will
illuminate for approximately two (2) seconds
and the fuel level, voltmeter and coolant
temperature gauges will indicate their
present conditions. This position is also
used for calibration of Combine
instrumentation (See Combine Calibration
in this manual).
D. START POSITION - Second position
clockwise from OFF. The starter motor will
crank the engine if the separator switch is
“OFF” and the propulsion control lever is in
the NEUTRAL position. Release the key
switch when the engine starts to run. After
the engine has started, the indicator lamps
will go OFF.
NOTE: To prevent operation by persons not
authorized to operate and to prevent excessive
discharge of the batteries, remove the key when you
leave the Combine.
448L96
RD05D057
KEY SWITCH POSITIONS
B
C
A
D
6
To Next Page
Loading...
