3.
Turn the Ignition Key all the way to the right to start the engine.
IMPORTANT: In the event of a "false start," that is, if the engine gets up
sufficient speed to disengage the starter but fails to continue
running,
the engine must be allowed to come to a complete
halt before a restart attempt is made. If the flywheel is still
rotating when the switch is engaged, the flywheel and starter
gears will clash and could be damaged.
Cranking time must be limited to 30 seconds followed by a
60 second cooling period to prevent overheating of the starting
motor. If an engine fails to start after this length of time,
ignition or carburetion troubles are indicated and should be
corrected before the engine is placed in operation.
4.
After the engine starts and runs, move the lever out of the choke position.
IMPORTANT: Do not attempt to start mower by pushing or towing as serious damage
to the drive system may result.
5. Always allow the engine to "warm-up" for a few minutes before operating under
load.
A
CAUTION:
Disenciaye all attachment clutches and shift into
neu-
tral before attempting to start the engine (motor).
WARNING: Improper operation of your riding lawn mower on
hill-
sides and slopes can be dangerous. Avoid improper operation!
Read and follow the instructions given in the section titled
"Hill-
side Operation" in this manual before operating your tractor.
STOPPING
THE
ENGINE
1.
An engine that has been working under load should idle for a few minutes so the
engine parts can cool evenly before it is shut off.
2.
Place all operating controls in neutral.
3. Turn ignition key to the "OFF" or upright position.
A
CAUTION:
Always shut off engine, remov(; key, set parking
brake,
and wait until all engine and mower motion has stopped be-
fore dismounting from the operaloi's
seal.
- 17 -
To Next Page
Loading...
