Controlling the Sound of a Performance
EN-39
4.
If required, press UPPER1, UPPER2, or LOWER to select the part whose setting
you want to configure.
5.
Rotate the dial to change the setting.
• You can specify a pitch bend in the range of 0 to 24.
• After you rotate the dial once to select a value, you can change the value further using – and +.
• To return the setting to its initial default, press – and + at the same time.
• To go back to the previous screen, press BACK.
• Setting a value of “0” causes the indicator for the applicable part (“U1”, “U2”, “L”) to disappear
from the display, and disable the pitch bender effect.
6.
To exit the setting operation, press EXIT.
• For details about parts, see “Layering and Splitting Tones” (page EN-52).
To Next Page
Loading...
