Controlling the Sound of a Performance
EN-40
You can use the procedure below to add reverb to the notes you play.
1.
Press MENU.
This displays the menu screen.
2.
Use U and I to select the 5 buttons menu that includes SYS FX.
3.
Press SYS FX.
This displays the system effect screen.
4.
Rotate the dial to select the reverb type.
The following shows the available reverb type settings.
• After you rotate the dial once to select a reverb type, you can change the selection further using
– and +.
• To return the setting to its initial default, press – and + at the same time.
• To go back to the previous screen, press BACK.
5.
To exit the setting operation, press EXIT.
Playing with Reverb
Reverb Type Display Name
Off Off
Room 1 to 5 Room 1 to 5
Large Room 1 or 2 Large Room 1 or 2
Hall 1 to 5 Hall 1 to 5
Stadium 1 to 2 Stadium 1 or 2
Plate 1 or 2 Plate 1 or 2
Delay 1 or 2 Delay 1 or 2
Church Church
Cathedral Cathedral
To Next Page
Loading...
